Universal Modules for the lights of a whole model. At each module individual LEDs may be connected. No additional resistors are needed as they are already integrated in the module!
The color of the LED to be connected is marked with a colored point on the module. One LED can be connected per outlet.
At the outlets marked with "HC" several LEDs (up to a total of 100mA) may be connected. In this case the correct resistor has to be determined and installed between the universal module and LED (only at the HC outlet)!
The big advantage of this set is that each module is connected by two wires only. This avoids a big mess of cables within the model. All light functions can be controlled with the Kingpad.
The modules are delivered ready to install and tested. The connection to the Kingbus lighting system is easy - simply plug them in!
Please note also the wiring diagrams at the pictures below.
Variants:
The modules are available in two variants. These differ in the Xenon light effect (flashing) when switching on the individual light functions. You may choose depending on your model if you want Xenon or Halogen head lights (without flashing).
Outlets Front Module:
- Parking lights
- Low beam head lights (only with parking lights)
- High beam head lights (permanently engaged only with low beam lights)
- Head light flasher
- Fog lights
- Turn signals left / right
- Hazzard flashers
- automatic curve light when turning or with turn signal
+ 5 Volt
Outlets Rear Module:
- Parking lights
- Rear fog light
- Brake light via driving channel
- Back-up light via driving channel or Kingpad
- Turn signals left / right
- Hazzard flashers
+ 5 Volt
Technical Data:
- Module dimensions 27 x 15 x 8mm (LxWxH)
- Cable lenght per module: 150mm
Delivery Contents:
- 1 Kingbus main module
- 2 Patch cables to connect the main module to the receiver
- 2 Universal Modules Front (left / right, either with or without Xenon light effect)
- 2 Universal Modules Rear (left / right)
- 1 Kingbus patch cable 50cm
- 1 Kingbus 4-way connector
