Kingbus PistenBully 600 Level Red 1:12

Light system for the PistenBully 600 Polar by Pistenking with only two wires.

The light modules are delivered fully assembled and tested. They just need to be installed in the model. No modifications are necessary on the driver cabin!

The lights can be controlled with the Kingpad (not included).

The Central Module & Kingpad are not needed for transmitters of the brands Brixl, ScaleArt Commander and Blauzahn.
Instead, the Kingbus-Interface is directly connected to the specific plug-in slot on the receiver. It will control the light functions via the standard Kingbus cables. 
The Kingpad is not needed in this case, as the light functions can be selected by switches and buttons on the transmitter.

The extension with new light module is simple - just plug them in! More details are found in the manual. 

Features:
- Parking lights
- Low beam head lights (only with parking lights)
- High beam head lights (permanently engaged only with low beam lights)
- Head light flasher
- Fog lights
- Back-up light via driving channel or Kingpad
- Work lights front and rear
- Turn signals left / right
- Turn signal reset via steering channel
- Hazzard flashers
- Rotating beacons
- Spot light connector
- Xenon light effect!

Technical Data:
- Operating voltage main module: 5 Volt from BEC
- Current: ca. 20 mA (idling)

Dimensions Main Module: 34 x 23,5 x 8 mm (L x B x H)

Delivery Contents:
- 1 Kingbus main module
- 2 Patch cables to connect to the receiver
- 1 Kingbus 4-way connector with 15cm cable
- 2 light modules front
- 2 light modules rear
- 6 electronic boards with wires for auxiliary headlights
- 2 rear lights modules with glas for the engine cover
- 1 search light, pre-assembled with plug (SH plug system)
- 1 universal module for installation within the engine cover