Ramp Actuator for Goldhofer TU4 Semi Trailer

The Goldhofer Semi Trailer TU4 by Veroma/Carson is widely used in the modelling scene. It can be seen at almost every modellers meeting. Unfortunately the two loading ramps can only be dumped by hand! This is now remedeed by Pistenking - by a special actuator set for the Goldhofer semi trailer TU4 which allows to radio control the ramps!
Our actuator kit is mounted to the model and controls the ramps with a motor gearbox combination. Each lower and upper end positions are secured by a limit switch!  
The limit switches are already wired and ready to install. Only the wires have to be soldered to the motor.
As a real big high light the ramps may even be moved sideways! Even as this is not possible by radio control it nevertheless enables the loading of rather small models.

IRAM: The operation is also possible without problems with our IRAM. There is no adapted version available. But as the limit switches are here already fix installed they do not have to be connected to the IRAM. The advantage is that only the motor wires from the IRAM to the ramp actuator have to be installed.

Delivery Contents:
- Motor gearbox combination
- Worm drive (worm is pre-installed on the motor)
- Limit switches, pre-assembled and wired
- New, one piece shaft for the ramps
- Side covers for the shaft
- New ramp mounts, fitting for the new shaft (laterally moveable!)
- Gear box base plate (works as drilling template)
- Gear box housing
- Instructions, screws, cables

- click for video of a similar product for a low bed semi trailer!